Corrugated edge deformation: This problem occurred in an example where a large infiltration belt conveyor at DT Power Plant discovered corrugated edge deformation after being put into use for one month The main problem occurs when all the return idlers in the horizontal section are D108x950 idlers, causing all the weight of the conveyor belt to sag to be transmitted to the idlers through the corrupted edge, increasing the conflict and kneading between the idlers and the corrupted edge, and then causing the corrupted edge to wear and deform during kneading

Insufficient lifting capacity: After using the high inclination belt conveyor for a period of time, the lifting capacity cannot reach the design capacity, which may be due to the material sticking to the belt and roller The material should be removed regularly based on the degree of elevation; It is also possible that the capacity of the front mechanical equipment is insufficient, resulting in a low amount of material input It is necessary to try to improve the production capacity of the front mechanical equipment

Unstable material flow rate: This may be due to improve or correct material measurement methods It is necessary to check the measuring device and verify the material specific gravity, and modify the calculation method from scratch

Belt slip page: During the operation of the large invasion belt conveyor, there may be a problem of belt slip page, which may be due to slow lifting speed or insufficient conflict force caused by material sticking to the belt and roller Responding measures need to be taken to improve this situation

Source of article: Manufacturer of large angle hoist Www.zsxianbang.com